Drainage System Facts

Drainage System Facts

The drainage system was designed around the turn of the 20th century, and much of its original equipment is still in use. It is comprised of more than 68,000 catch basins, 1,500 miles of lateral, underground drainage pipes, 200 miles of open and underground canals and 120 pumps housed in 24 drainage pump stations (DPS).

The system starts on your roof and chiefly runs on gravity. Runoff goes into the streets, then enters the network through the catch basins. Storm water must then travel through pipes and canals to reach the pump stations, which send it either into outfall canals or directly into Lake Pontchartrain or nearby waterways.

Of our 120 pumps, 51 run on an older frequency of electricity, 25 Hertz (Hz). We produce that power ourselves using steam turbine generators, frequency changers and Electro-Motive Diesel (EMD) generators. In all, we need about 52 megawatts (MW) of power to fully run the drainage system. We can produce more than 80 MW, giving us vital redundancy in our power supply.

The remaining pumps run on modern, standardized 60 Hz power.

Our smallest pumps are called “constant duty” or “dry weather” pumps because they are most often used to regulate groundwater that seeps into canals. We have 21 of those.

Our workhorse drainage pumps can be as big as 14 feet across and can each move approximately 1,100 cubic feet of water per second (that’s the equivalent pumping power of more than 700 fire trucks). We have 99 pumps solely focused on drainage.

Because our pumps are different sizes and serve different purposes, we do not and cannot run all our drainage pumps at the same time. In some cases, to do so would overflow downstream canals, causing neighborhood flooding. Should a pump go offline, these extra pumps are there to be quickly turned on and put to use. That’s another area of vital redundancy.

While impressive, the system has its limitations. When it was designed more than a hundred years ago and built afterward, its engineers estimated it can move about half an inch of water every hour after rain fills the underground canal and pipe systems. The pumps cannot be activated until storm water reaches them by gravity. Intense rainstorms that drop more than an inch of water in an hour will most likely outpace the system’s capability, leading to street flooding until it can catch up.

When water is flowing swiftly through canals, residents can be assured the pumps downstream are working.

Please explore the map attached here to see where our pump stations are located, what neighborhoods they drain, and where the water goes.

Learn more about our drainage system's capacity from a historical perspective by reading this informational document produced by BCG Engineering & Consulting.

Validation error occured. Please enter the fields and submit it again.
Thank You ! Your email has been delivered.